Quadro-Layer Enameled SPCC Tank with Longer Product Life
Customized Minimum Startup Pressure for Low Water Pressure Condition
Vitreous Enamel Coating l inside Inner Tank
Thermostat
Mechanical Temperature Control
Always follow the instructions given by Abans service team, when buying / installing instant water heaters.
To be installed the unit with a power connection through a 2 pole circuit breaker (MCB) instead of Plug top and base. The whole power circuit for the unit must allow the maximum power consumption of the water heater. Because, a longer run with a current consumption more than 13A through a plug top and base (13A) will make the plug top burn.
The MCB should be matched according to the current and voltage rating of the unit. Always follow the instructions for installation and electrical connections according the product manual individually for your own safety.
And also this is applicable, any water heater either with pump or without pump, if maximum current consumption is more than 13A
If you have any clarification or any questions with regards to below matter,
Please contact Mr. Rajintha Ravishan under below mention contact number or email address:
Tel :- +94 11 599 6009 Email :- [email protected]
Temperature Range |
25-75 Celsius |
Thermal Cut Off |
Capillary Thermal Cut out |
Water Proof Grade |
IPX 4 |
Safety Valve(MFV) |
Yes |
Rated Pressure Mpa |
0.8 |
Pressure Range for MFV Mpa |
0.015-0.8 |
We Support the following Payment Methods
Installment Plans
Write a Review